|
Product Details:
|
| Name: | Plastic Fixing Pins | Material: | PP, PE, Nylon, Steel |
|---|---|---|---|
| Pin Dia: | M8-M12 | Pin Length: | As Request |
| Washer Size: | 50mm,60mm In Common | Small Order: | Support |
| Highlight: | duct insulation pins,insulation anchors |
||
Performance parameter of plastic fixing pins with nail inside/nylon frame fixing anchors
According to the JG/T366-2012 standard;
Knocking anchor: Tap the expansion joint or expansion sleeve to squeeze the borehole wall to create an expansion anchor.
Claim:
1. The nominal diameter of the disk of the disc anchor should not be less than 60mm and the tolerance is 1.0mm. The nominal
diameter of the expansion sleeve should not be less than 8 mm with a tolerance of ±0.5 mm.
2. Standard value of anchorage capacity of anchor bolt: standard value of tensile load capacity of anchor bolt Fk≥0.60
3. Anchor bolt disc tensile force standard value: disc pullout standard value Frk≥0.50
data sheet of plastic fixing pins / nylon frame fixing anchors
| Pin Size | Pin Dia | Pin Length | Washer dia | Packaging |
| M8x50 | 8mm | 50mm | 45mm-60mm,could be customized | 1000pcs / carton |
| M8x60 | 8mm | 60mm | 45mm-60mm,could be customized | 1000pcs / carton |
| M8x90 | 8mm | 90mm | 45mm-60mm,could be customized | 1000pcs / carton |
| M8x110 | 8mm | 110mm | 45mm-60mm,could be customized | 1000pcs / carton |
| M8x140 | 8mm | 140mm | 45mm-60mm,could be customized | 1000pcs / carton |
| M10x160 | 8mm | 160mm | 45mm-60mm,could be customized | 1000pcs / carton |
| M10x190 | 8mm | 190mm | 45mm-60mm,could be customized | 1000pcs / carton |
Features of the plastic fixing pins/nylon frame fixing anchors
1. For fastening of all insulation materials.
2.Denser insulation materials
3.Rough cast head provides a key for render
4.With high efficiency, low cost, anti-aging, anti-thermal shock, anti-corrosion, cold and heat
5. High pressure, good tensile properties
6.Undeformed, moisture, slow vibration, noise absorption and sound insulation effection
First, we need to use electric drill to drill specific size of the hole
Second, putting expand plug in the hole
Finally, using a screwdriver to tighten screw into the expansion tube until the specified location
The arrangement of the external wall nylon fixing anchors.
The number of anchors installed on the outer wall insulation system of the extruded board;
the average of 1-10 layers is 6/m2, the average of 11-20 layers is 7/m2, and the layers of 21-26 are 9/m2. Any single block
with an area greater than 0.1m2 must be anchored, depending on the shape and site conditions;
the density of the anchor should be increased around the angle of the sun, under the mouth, and around the edge of the hole.
The distance is not more than 300mm, from the edge of the base. Not less than 60mm
Contact Person: David
Tel: 86-18732199987
Fax: 86-1336-3891298
